Enterasys-networks XSR-3020 Manual do Utilizador descarregar pdf (Página 38)

Installing a CompactFlash Memory Card

2-6 Hardware Installation

2. Seat the card in the PCMCIA interface as shown in Figure 2-8.

Gently insert the CF into the slot, taking care that the CF’s wider grooved edge fits into the

wider track of the PCMCIA interface. If the card does not seat easily but stops halfway into the

slot, do not force it in - the card was inserted incorrectly. Flip it over and re-insert. Note that

the XSR’s CF eject mechanism pops out for easy removal when you install the card. Also, you

can re-attach the cover after the CF card is installed for added security.

Figure 2-8 Installing CompactFlash Card

CompactFlash Card for the ADSL NIM

The ADSL NIM is shipped with a CompactFlash card carrying the DSP firmware necessary for

connecting to a DSAM. Refer to Figure 2-13 for an illustration and installation instructions.

Formatting the CompactFlash Card

If your CF is not formatted, there are two ways you can format the card:

• Use the XSR Bootrom Monitor Mode

ffc command. A few seconds after you boot up the XSR,

press the

CTRL-C keys and a password prompt will appear. Press ENTER (factory default) if

you have not defined any password. The Bootrom Monitor Mode will appear. Enter

ffc and

the router will complete the formatting.

• Install the CF in a PCMCIA card and enter the Windows format command. For further

instructions, refer to Windows documentation.

• After completing CF formatting via Bootrom Monitor Mode, use the

bc command to restart

the XSR in normal mode.

NIM 2

1000

Link

10/100/1000

XSR-3020

COM

PWR

SYS

NIM1 NIM2

VPN

NIM1 NIM2

VPN

COM

ETH3ETH2

ETH1

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 109 110

Sem comentários

Enterasys-networks XSR-3020 Manual do Utilizador Página 38