Enterasys Networks CSX7000 Manual do Utilizador descarregar pdf (Página 624)

100

101

USER’S GUIDE

624 CyberSWITCH

sentry log

This command acts as a toggle switch, enabling or disabling user authentication rejection

messages. If enabled, authentication rejection messages (identifying users who generated the

messages) are written to the log file. To display the log file, issue the

console command. This

option is initially disabled.

sentry status

Displays current Sentry status. This includes whether or not trace is enabled, as well as the

status and port number of each authentication server on the system.

sentry tacacs

Attempts an authentication session using TACACS. The system will report whether the

authentication attempted was successful or rejected.

sentry radius

Attempts an authentication session using RADIUS. The system will report whether the

authentication attempted was successful or rejected.

sentry ace

Attempts an authentication session using ACE. The system will report whether the

authentication attempted was successful or rejected. Upon initial configuration of ACE, this

command also establishes a secret for the CyberSWITCH and the ACE server. This secret is

necessary for future authentication negotiations.

WAN COMMANDS

The following commands are used to display current system WAN diagnostic information:

wan fr-ietf stats [device/fr_accessname_dlci] [prot]

Displays the current frame relay IETF related statistics. Refer to WAN FR_IETF Statistics, for a

list of available statistics and their definitions.

wan l1p

This group of commands provide primary rate interface layer 1 information.

wan l1p

is the

prefix for all commands in this group. The syntax and definition for each wan l1p command

follows. (Note that for each command, you must include the slot number of the PRI adapter.)

wan l1p alarm display <slot #>

Displays any alarms currently being received by the primary rate layer 1. Because many

incoming alarms are qualified for several seconds before being declared, this display may

indicate an alarm when layer 1 has not been declared down. The following table provides the

possible alarms and their meanings.

1 2 ... 619 620 621 622 623 624 625 626 627 628 629 ... 728 729

Comentários a estes Manuais

Sem comentários

Enterasys Networks CSX7000 Manual do Utilizador Página 624

Comentários a estes Manuais