Enterasys Networks CSX7000 Manual do Utilizador descarregar pdf (Página 371)

100

101

Central Site Remote Access Switch 371

ONFIGURING

ALL

ONTROL

Call Interval Parameters

CALL INTERVAL PARAMETERS

CONFIGURING THE CALL INTERVAL PARAMETERS

USING CFGEDIT

1. Select Call Intervals from the Call Control Options menu.

2. Enter the minimum time interval between call attempts.

CALL INTERVAL CONFIGURATION ELEMENTS

MINIMUM TIME INTERVAL

The configured call interval is the minimum time between call attempts. The system will not make

a call attempt in less than the configured call attempt value. However, due to the system hardware

clock resolution, the actual time interval may be greater than the configured value. The default

value is 0.70 seconds. The range of the configured value is 0 to 5 seconds, in 1/100 second

increments. A configured value of 0 implies that the system will make call attempts without any

delay between them.

CALL INTERVAL BACKGROUND INFORMATION

This parameter allows the configuration of the minimum interval between call attempts. This

interval applies to the entire system, including all lines, sites, and devices.

The Call Interval is configured in terms of hundredths of seconds. The default value is .7 seconds.

The range of the configured value is 0 to 5 seconds. A configured value of 0 implies that the system

will make call attempts without any delay between them.

The default value of .7 seconds is compliant with the Communications Industries Association of

Japan’s(CIAJ) regulation. This regulation states that no customer premise equipment should make

more than 3 call attempts within 2 seconds. This prevents certain model switches from being

overloaded. In areas where these low capacity switches are not installed, calls can be made more

frequently.

Before the system initiates a data connection, it first checks the time at which the last connection

was initiated. If the time from the last connection attempt to the new connection attempt is less than

the configured call interval, the new connection is placed on an outgoing call queue. The queue is

then serviced at the configured call interval.

MONTHLY CALL CHARGE

CONFIGURING MONTHLY CALL CHARGE

USING CFGEDIT

1. Select Call Charges from the Call Control Options menu.

2. Follow the onscreen instructions to enable this feature.

3. Enter the maximum monthly charge you would like to set (specified in Yen for NTT

connections).

4. Select the action to take if the maximum is exceeded.

1 2 ... 366 367 368 369 370 371 372 373 374 375 376 ... 728 729

Comentários a estes Manuais

Sem comentários

Enterasys Networks CSX7000 Manual do Utilizador Página 371

Comentários a estes Manuais