Enterasys Networks CSX7000 Manual do Utilizador descarregar pdf (Página 411)

100

101

Central Site Remote Access Switch 411

ONFIGURING

THER

DVANCED

PTIONS

Compression Options

COMPRESSION OPTIONS CONFIGURATION ELEMENTS

COMPRESSION SUBSYSTEM STATUS

You may enable or disable the compression subsystem status. This option provides enable/disable

control over the entire compression subsystem within the system. If this option is enabled, the

system will negotiate compression with remote devices per their individual device compression

configuration. If this option is disabled, the system will not negotiate compression with any remote

device. The default value is enabled.

Note that enable/disable applies to all protocols which support compression.

EFAULT PER-DEVICE COMPRESSION SETTING

You may enable or disable the per-device compression setting. This is in addition to the global

compression enable/disable state described above. The Default Per-Device Compression setting

defines the initial value for the per-device state when you add a new device to the on-node device

table. Or, if the device is authenticated via an off node server, the device will be given its

compression enable/disable state based on this value when no value is delivered by the off-node

database.

You may later change a specific device’s enable/disable state.

The per-device compression enable/disable state is only supported for connections using the PPP

protocol. The default value is enabled.

TARTING PPP STAC-LZS SEQUENCE NUMBER

Default value is 1. When using PPP Compression with the STAC-LZS protocol, a sequence

numbering scheme can be used whose initial value is required to be 1 by the protocol specification.

Some devices from other vendors do not start with 1. This results in a resynchronization sequence

on the first frame which is exchanged. When the user device fully supports the CCP protocol’s

Reset mechanism, this will only result in the minor inconvenience of a lost frame at the beginning

of a session. However, if such a device’s resynchronization mechanism is to completely renegotiate

CCP, this sequence will repeat infinitely.

This option provides an escape mechanism to allow interworking with such devices by modifying

the initial PPP STAC sequence number.

The Starting PPP STAC Sequence Number is maintained for each device. The value which appears

on this configuration screen provides the default value for the per-device value. When you add a

new device to the on-node device table, that device’s starting sequence number option will be

assigned the value which appears on this screen. You can then change this for each individual

device. Or, if the device is authenticated via an off node server that does not deliver a value for this

configuration item, the device will be given its starting sequence number from the value on this

As its name implies, this option only applies to connections which utilize the PPP protocol with

STAC-LZS compression and sequence numbers checking.

1 2 ... 406 407 408 409 410 411 412 413 414 415 416 ... 728 729

Comentários a estes Manuais

Sem comentários

Enterasys Networks CSX7000 Manual do Utilizador Página 411

Comentários a estes Manuais