Enterasys Networks CSX7000 Manual do Utilizador descarregar pdf (Página 379)

100

101

Central Site Remote Access Switch 379

ONFIGURING

ALL

ONTROL

Semipermanent Connections

BANDWIDTH RESERVATION BACKGROUND INFORMATION

This feature allows a portion of the possible connections to always be available to specific devices

for both inbound and outbound calls. To increase flexibility, this feature may be configured to

either allow or prevent bandwidth overlap. Bandwidth overlap will allow normal devices to use a

certain number of lines, while a special class of super devices would be allowed access to both the

normal bandwidth (designated in the default profile) as well as special super device bandwidth

(designated in the configured device profile). "No overlap" would restrict each set of devices to

their own lines.

When configuring your bandwidth reservation, consider the following:

• This is a BRI-only feature since bandwidth is reserved per-line.

• It is necessary to reject calls from devices who have mistakenly called in on a line reserved for

other device(s).

• Outbound calls are also restricted to the lines reserved for a device.

• When Bandwidth Reservation is disabled, any device will can connect on any line.

• When Bandwidth Reservation is enabled, a default profile list of lines will be configured for use

by all devices that are not configured to use an alternate profile in the reserved list. This default

profile list may be configured to remove lines from general use.

SEMIPERMANENT CONNECTIONS

A semipermanent connection is a connection that is up at all times. With semipermanent

connections, one or more switched calls are made at system start-up, and are kept up until system

shutdown. This feature minimizes the number of calls which the system makes, and maximizes the

number of active call minutes.

Every device can have one semipermanent connection. Each semipermanent connection is com-

posed of one or more calls. The number of semipermanent devices is limited to the maximum num-

ber of calls allowed by the system.

CONFIGURING SEMIPERMANENT CONNECTIONS

Note: The initial data rate for both sides of the connection must either be configured identically or

the throughput monitor feature must be turned off for the remote side of the connection.

SING CFGEDIT

1. Select Options from the main menu.

2. Select Call Control Options from the Options menu.

3. Select Semipermanent Connections from the Call Control Options menu.

4. Press 1 to add a semipermanent connection.

5. Enter the device name to associate with the connection as shown below:

Enter the name of the device to add to the semipermanent device list

or <RET> to cancel menu: Mike Mason

1 2 ... 374 375 376 377 378 379 380 381 382 383 384 ... 728 729

Comentários a estes Manuais

Sem comentários

Enterasys Networks CSX7000 Manual do Utilizador Página 379

Comentários a estes Manuais