Enterasys Networks CSX7000 Manual do Utilizador descarregar pdf (Página 478)

100

101

USER’S GUIDE

478 CyberSWITCH

ISDN line failure. The line connected to slot “s” port “p” is out of service for the reason indicated

by #.

1 = No layer 1 sync for 5 seconds

This problem normally occurs due to WAN cabling problems.

Check your cables to make sure they are connected correctly. If the problem still occurs

after you have checked all the cables, call the phone company and report the problem.

2 = No response to TEI requests

This problem normally occurs due to invalid configuration.

Check your configuration using the following table:

3 = No UA response to SABME requests; no Layer 2

This problem normally occurs due to invalid configuration.

Check your configuration using the following table:

4 = Network sent CAUSE - invalid SPID

This problem normally occurs due to an invalid SPID configuration.

Enter the correct SPID for the line. If you think that the correct SPID has been entered,

contact your phone company.

5 = Network sent init, but no SPID configured

This problem normally occurs because the SPID was not configured. Configure the correct

SPID for the line.

Out Svc # (s,p)

basic rate only line from phone

company:

point-to-point

line from phone

company

multi-point (Japan

only)

line configured on

system:

non-auto TEI

make sure that the

configured system

TEI value is 0

change TEI to be

AUTO

line configured on

system:

auto TEI

change system TEI to

be non-auto

if problem happens

for over 5 minutes,

report problem to

phone company

basic rate and

primary rate

line from phone co:

point-to-point

line from phone co:

multi-point (Japan

only)

line configured on

system:

non-auto TEI

make sure that the

configured TEI value

is 0

change TEI to be

AUTO

line configured on

system:

auto TEI

change TEI to be non-

auto

if problem happens

for over 5 minutes,

report problem to

phone company

1 2 ... 473 474 475 476 477 478 479 480 481 482 483 ... 728 729

Comentários a estes Manuais

Sem comentários

Enterasys Networks CSX7000 Manual do Utilizador Página 478

Comentários a estes Manuais