Enterasys Networks C2K122-24 Manual do Utilizador descarregar pdf (Página 43)

Connecting AC and RPS Power

SecureStack C2 Installation Guide 3-13

1. Ensurethatpowerisoffonthe newswitchbeinginstalled.

2. Useoneofthefollowingmethodstocompletethestackcableconnections:

–Iftherunningstackusesadaisychaintopology,makethestackcableconnections

fromthebottomofthestacktothenewswitch(thatis,STACKDOWNport

from

thebottomswitchoftherunningstacktotheSTACKUPportonthenewswitch).

–Iftherunningstackusesaringstacktopology,breaktheringandmakethe stack

cableconnectionstothenewswitchtoclosethering.

3. Applypowertothenewswitch.

Connecting AC and RPS Power

AC Power

ToconnectaswitchtotheACpowersource,refertoFigure 3‐7andproceedasfollows:

1. Plugthepowercord

intotheswitchACpowerconnector.

2. PlugtheotherendofthepowercordintoadedicatedgroundedACoutlet(not

shown).Thetypeofpoweroutletandpowercordarecountrydependent.

Important Considerations About Using Clear Config in a Stack

When using the clear config command (as described in the SecureStack C2 Configuration Guide)

to clear configuration parameters in a stack, it is important to remember the following:

• Use clear config to clear config parameters without clearing stack switch IDs. This command

WILL NOT clear stack parameters and avoids the process of re-numbering the stack.

• Use clear config all when it is necessary to clear all config parameters, including stack switch

IDs and switch priority values.

Note: The power supply in the switch has automatic voltage sensing that allows

connection to power sources ranging from 100 to 240 VAC.

Note: If you plan to connect all the switches quickly to allow automatic Manager selection,

wait until all switches are fully operational before proceeding to the next step.

If you plan to power up each switch and allow it to become fully operational before

applying power to the next switch, proceed to the next step.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 69 70

Sem comentários

Enterasys Networks C2K122-24 Manual do Utilizador Página 43