Enterasys-networks Enterasys Matrix 9034310-01 Manual do Utilizador descarregar pdf (Página 26)

Unpacking the DFE-Platinum Module

3-2 Installation

Unpacking the DFE-Platinum Module

UnpacktheDFE‐Platinummoduleasfollows:

1. OpentheboxandremovethepackingmaterialprotectingtheDFE‐Platinummodule.

2. VerifythecontentsofthecartonaslistedinTable 3‐1.

3. Removethetapesealonthenon‐conductivebagtoremovetheDFEmodule.

4. PerformavisualinspectionoftheDFE‐

Platinummoduleforanysignsofphysicaldamage.

ContactEnterasys Networksifthereareanysignsofdamage.Referto“GettingHelp”on

page xiii fordetails.

Installing Optional Network Expansion Modules

APhillipsscrewdriverisneededtoinstallanoptionalNEMintothe2G4082‐25.

Atthetimeofthisprinting,onlythe7G‐6MGBIC‐ANEMisavailableforthe2G4082‐25.Referto

yourreleasenotesforthelatestavailableEthernetinterface modules.The7G‐6MGBIC‐Aprovides

sixGigabit

portslotsforoptionalMini‐GBICconnections.

InstallinganoptionalNEMinvolves

•removingthecoverplatefromtheDFE‐Platinummodule,

• attachingtheNEMtotheDFE‐Platinummodule,and

•ifrequired,installingMini‐GBICs.

Formoreinformation,refertotheQuickReferencethatwasshippedwithyourNEM,ortheMatrix

NetworkExpansion

ModuleHardwareInstallationGuidelocatedontheEnterasys Networkswebsite.

Installing Module into Matrix E7 or N7 Chassis

Toinstalla2G4082‐25intoaMatrix E7orMatrix N7 chassis,proceeddirectlyto“Preparation”on

page 3‐3tostarttheinstallationprocess.

Table 3-1 Contents of DFE-Platinum Module Carton

Item Quantity

DFE-Platinum Module (2G4082-25) 1

This Installation Guide 1

Customer Release Notes 1

Note: Install any optional equipment before installing the 2G4082-25 into a chassis.

Caution: Failure to observe static safety precautions could cause damage to the DFE module.

Follow static safety handling rules and wear the antistatic wrist strap.

Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or

components can cause damage.

Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de

electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad para la

manipulación del producto y no olvide utilizar la pulsera antiestática.

No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto cortante

entra en contacto con la placa o con los componentes, éstos podrían dañarse.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 57 58

Sem comentários

Enterasys-networks Enterasys Matrix 9034310-01 Manual do Utilizador Página 26