Enterasys Networks G3G124-24 Manual do Utilizador descarregar pdf (Página 32)

Installing and Removing an IOM

2-10 Installation

Figure 2-3 Installing a PoE module in the G3G-24TX IOM

4. UsingthescrewsshippedwiththePoEmodule,firmlyattachthePoEmodule totheIOM.

Installing an IOM

IfyouhaveoneormoreIOMsthatyouwishtoinstallintotheswitch,youshoulddosobeforeyou

connectpowertotheswitch.BeawarethatanyIOMmoduleinsertedintoarunningswitchwill

notberecognizeduntiltheswitchisrebooted.

ToinstallanIOMmodule,

refertoFigure 2‐4andproceedasfollows:

1. AttachanESDwriststraptoyourwrist.

2. Unpackthemodulebytakingitfromitsshippingboxandremovinganypackagingmaterials,

andremovingthemodulefromitsprotectiveplasticbag.(Savetheshippingboxand

materialsintheeventtheunitmust

bereshipped.)

3. Examinethemodulecarefully,checkingfordamage.If anydamageisfound,donotinstallit.

ContactEnterasys Networksforinstructions.

4. Removethecoverplatefromtheslot.

5. InserttheIOMintheguiderailoftheslot.Gentlyslidethemoduleintotheslot,asshownin

Figure 2‐4,until

theIOMengagestheconnectoronthebackplaneandthemodulelocksinto

placeandisflushwithadjoiningcoverplates.

6. Tightenthetwocaptivescrews.

1 Fastening screws 4 IOM connector

2 PoE daughter card module 5 G3G-24TX IOM module (motherboard)

3 IOM to PoE connector

Note: IOM modules can be hot-inserted into the G-Series switch, but must be removed by following

the procedure described in “Removing an IOM” on page 2-11.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 58 59

Sem comentários

Enterasys Networks G3G124-24 Manual do Utilizador Página 32